BYD TANG 2024 - Wiper Switch

→ Vehicle → Exterior Light
(default: 10 seconds). With the light
adjustment switch turned to "
", "
" or " ", when you unlock the
vehicle and attempt to approach it,
the corresponding lights will light up
for 10 seconds (or the set time).
Wiper Switch
Front Windshield Wipers and Washer
●
The lever is used to control the
windshield wipers and washer. It has
󽗉ve modes:
●
: Fast
●
: Slow
●
: Automatic/Intermittent
●
: O󽗈
●
: Point-wiping
●
Push up or pull down the lever to
select a mode.
●
In slow and fast modes, the wiper
operates continuously.
●
Pulling down the lever from the
position activates the point-wiping
mode
. The wipers wipe at a low
speed until you release the lever.
Auto Wipers/Intermittent
●
The rain sensor automatically controls
the operation mode of wipers based on
the rainfall, and it is located in front
of the interior rearview mirror on the
front windshield inside the vehicle.
●
To use the auto wiper function, turn
the wiper switch to the automatic
mode and go to the infotainment
touchscreen → Vehicle →
Comfortable Use.
●
To use the intermittent wiper function,
turn the wiper switch to the automatic
mode, and disable auto wiper on
infotainment touchscreen
→
Vehicle → Comfortable Use.
●
The automatic wiper function has four
sensitivity levels. The higher the lever,
the higher the sensitivity. When using
the automatic wiper function, change
the sensitivity by adjusting the toggle
based on real-time rain conditions. If
the wiper reacts to rain too quickly,
reduce the sensitivity; if the wiper
reacts to rain too slowly, increase the
sensitivity.
WARNING
●
If the wiper switch is on with
the ignition on, touching the glass
on the top of the sensor by hand
or wiping it with a cloth can cause
the wiper to work and thus lead to
an accident.
77
03
CONTROLLER OPERATION