C-Nav IALA - Page 7

C-Nav Hardware Reference Guide
7
Figure 3-50: C-NaviGator II Side-panel Connectors ............................................................................................................................... 53
Figure 3-51: C-NaviGator II Power Supply .............................................................................................................................................. 53
Figure 3-52: RAM 100 75 VESA Base (w/ Steel Reinforce) / RAM-D-246U-IN1................................................................................... 55
Figure 3-53: RAM Double Socket Arms .................................................................................................................................................. 55
Figure 3-54: RAM 11" X 3" Base (w/ Steel Reinforce) / RAM-D-111B-IN1U (left) & ............................................................................. 55
Figure 3-55: Flat Screen Table Stand (for C-NaviGator II) / CHIFSB018BLK ....................................................................................... 56
Figure 3-56: Tilting VESA Wall Mount (for C-NaviGator II) / PEEST630 ............................................................................................... 56
Figure 3-57: Front Mount Kit (for C-NaviGator II) / SYNIWO-6710-7CRBR2 ........................................................................................ 57
Figure 3-58: 19” Mounting Kit (for C-NaviGator II) / SYNIWO-6710-7CBR9 ......................................................................................... 58
Figure 3-59: C-NaviGator II (side USB-port model) Outline Diagram (mm)........................................................................................... 59
Figure 3-60: C-NaviGator II Cut-out Diagram (mm) ................................................................................................................................ 60
Figure 3-61: C-NaviGator II rev. A (front USB-port model) Outline Diagram (mm) ............................................................................... 61
Figure 4-1: Huber + Suhner Model No. 3403.17.0045 ............................................................................................................................ 64
Figure 4-2: Huber + Suhner Model No. 3402.17.0070 ............................................................................................................................ 66
Figure 4-3: Moxa TCC-80I Converter Dimensions .................................................................................................................................. 70
Figure 4-4: TCC-82 Converter Dimensions ............................................................................................................................................. 71
Figure 4-5: LMR400 Attenuation vs. Frequency Graph .......................................................................................................................... 73
Figure 4-6: LMR400 Connectors.............................................................................................................................................................. 73
Figure 5-1: Components for Termination of Coaxial Cable .................................................................................................................... 75
Figure 5-2: Prep/Strip Tool (large end) .................................................................................................................................................... 75
Figure 5-3: Duburring Tool ....................................................................................................................................................................... 76
Figure 5-4: Prep/Strip Tool (smaller end) ................................................................................................................................................ 76
Figure 5-5: RMA Flux Application ............................................................................................................................................................ 77
Figure 5-6: Soldering ................................................................................................................................................................................ 77
Figure 5-7: Connector Installation ............................................................................................................................................................ 78
Figure 5-8: Ferrule Crimping .................................................................................................................................................................... 78
Figure 5-9: RG-59U Coaxial Cable .......................................................................................................................................................... 79
Figure 5-10: Coaxial cable with Barrel Connector................................................................................................................................... 79
Figure 5-11: Coax-seal Roll ..................................................................................................................................................................... 80
Figure 5-12: Coax-seal Application.......................................................................................................................................................... 80
Figure 5-13: Coaxial Cable Fully Sealed ................................................................................................................................................. 81
Figure 5-14: Coax-seal Cross-section ..................................................................................................................................................... 81
Figure 6-1: DTE to DCE RS-232 Pin Assignments ................................................................................................................................. 92