20
※Full charging time is about 8 hours (depending on degree of battery discharge); please
do not charge continuously for more than 15 hours.
※Please charge in a well-ventilated place and avoid charging in outdoor or rainy
environments.
※In order to avoid overvoltage of the battery, the battery connection cable set has a high
voltage protection function. If the battery connection cable set is damaged, please
replace with a new one immediately.
※When reassembling the battery connection cable, please pay attention to the battery
"+" / "-" terminals and connect them correctly to prevent the risk of danger or damage.
a
c
b
3-5 Charging operation instructions :
※For original charger only
Step 1 : Open the charger socket (b) cover, take the charger (a)
attached to the scooter, insert the charging plug into the car
charger socket (b), and then plug the other AC power plug
(c) into the power socket. Then check if the charging indicator
light on the charger (a) is on. If so, charging is in progress.
Step 2 : For safety reasons, please operate according to the above
method. Once fully charged, please turn off the charger (a),
unplug the 110V power plug, and then remove the charging
plug.
Step 3 : When fully charged, the charging indicator light will turn
green, but do not stop charging immediately. In order to
fully charge the battery, you may charge it again.
•Charger failure and troubleshooting
※The power charging indicator light (red light) is not on :
Troubleshooting → Confirm whether the socket has normal voltage.
If the socket voltage is normal, please replace with a new charger
immediately.
※The charging indicator light (orange light) is not on :
Troubleshooting → Confirm that the charging output connector is properly connected to the battery
connector. If it is, a battery failure may have occurred, and the old charger should be replaced
with a new one.
※The charging indicator light (orange light) flashes quickly (to green light) :
Troubleshooting → Confirm that the battery is fully charged. If not, a battery failure may have
occurred, and the old charger should be replaced with a new one.
Charging indicator :
Standby : red light
Charging : orange light
Full charged : green light
H
F
E
SPD TRIPODO
The display panel automatically switches to the SPD speedometer mode while in the charging
state.
Display status as shown
on the following page
Symbol flashing
※The AC power plug must be plugged directly into an
AC socket on the wall. To avoid danger, do not use
an extension cable or adapter plug. When connecting,
please make sure that both ends of the connectors
are dry and clean.
To Next Page
Loading...
Need help?
General
