45
Check for troubleshooting
N-D lever
Buzzer
Battery indicator
Rear mirror
Starter lever
Headlight
Speed adjustment
button
Armrest
Tire
Motor
Charger
Seat board
Electric equipment
Is the gear adjustment abnormal?
Does it set off a sound when working?
Is the battery indicator light on?
Is the low power alarm displayed?
Is there a situation of defacement?
Is it loose?
Is it normal to move forward / backward?
Is the electromagnetic brake normal?
Is the warning light/brake normal?
Is the headlight / turning light normal?
Is the function normal?
Does it shake?
Is there any air leakage / cracking / yellowing /
foreign material penetration?
Is the wheel pattern depth (0.5 mm) sufficient?
Is the front/rear wheel shaking when rotating?
Is there any abnormality / uneven sound during
operation?
Is the charging operation normal?
Is the whole function smooth and fixed?
Is the battery terminal loose?
Is the battery line off or damaged?
9-2 Electromagnetic brake
maintenance
4-3 Control panel maintenance
3-5 Charging operation instruction
Please clean and wipe
Please lock and adjust
4-5 Maintenance of the VR initiator
controller
9-2 Electromagnetic brake
maintenance
5-5 Headlight maintenance
5-6 Turn light maintenance
8-8 Tail light maintenance
4-3 Control panel maintenance
Please fix the fixing screws
8-1 Front wheel maintenance
8-3 Rear wheel maintenance
9-1 Motor maintenance
3-5 Charging operation instruction
7-1 Seat board maintenance
3-4 Battery connection cable
disassembly
3-4 Battery connection cable
maintenance
Checked part Check content Processing method
Self-Diagnostic Warning Light
1
2
3
4
5
6
7
8
9
Battery Low
Low Battery Fault
High Battery Fault
Current limit time-out or controller overheat
N-D lever is not set to D-position
The throttle is not in Neutral
Starter lever or related cable failure
Motor Voltage
Controller failure or overheating
The batteries are running low.
※Recharge the batteries.
The batteries have run out of charge.
※Recharge the batteries.
※Check the battery and associated connections and
Disconnect the battery pack, and check the battery condition.
Do not drive up steep slopes or overload the scooter.
Switch to D (drive) position. Turn off the power and turn on
again.
Release the throttle to restart. If it is invalid, refer to the throttle
maintenance.
Refer to the panel maintenance. If it is invalid after the
connector is reconnected, replace it with a new one.
The motor or its associated wiring is faulty. ※Check the motor
and associated connections and wiring.
Refer to the controller maintenance, replace with a new part
if it is invalid after the connector is reconnected. Stop the
scooter for 10-15 minutes to let the controller cool down.
Number of
flashes
Possible cause : Processing method
To Previous Page
Loading...
Need help?
General
