Us e r 's GU i d e — 19
While in the Paperless Tape mode, the display will show the
previously entered or calculated value, along with the sequential
number of the entry (e.g., 01, 02, 03, etc.) and the math operator
(+, –, x, ÷, %) in the upper left corner of the display.
Note: If
=
has been used in the middle of a sequence, SUB (for
Subtotal) will display in the upper left. If
=
was the last operation
performed, the display will show TTL (Total) as the last entry.
To exit this mode, press
=
to exit and maintain the last entry
on the display. When exiting, the last entry (or TTL) will be
displayed, allowing you to continue using the last tape value
for another operation, if desired.
Note: The Paperless Tape is cleared when you do one of the following:
-
O
is pressed twice
- upon a new calculation (new equation string is started)
- when the calculator is shut off.
Add a sequence of values and access Paperless Tape mode to
review your entries. Then, add another value to your total.
KEYSTROKE DISPLAY
1. Add a sequence of values:
OO
0.
100m+
100. MM
190m+
290. MM
150m+
440. MM
95m=
535. MM
2. Access the Tape function:
g=
TTL = 535. MM
3. Scroll from rst value to total:
+
01 100. MM
+
02+ 190. MM
(cont’d)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
