Chapter 17: Ethernet Services and Interfaces (CLI)
Viewing Ethernet PMs and Statistics (CLI)
phn-3963_004v000
Page 17-319
To display RX packet PMs in 15-minute intervals, go to interface view for the interface and enter
the following command:
eth type eth [x/x]> pm show rx-packets interval 15min
To display RX packet PMs in 24-hour intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show rx-packets interval 24hr
To display RX broadcast packet PMs in 15-minute intervals, go to interface view for the interface
and enter the following command:
eth type eth [x/x]> pm show rx-bcast-packets interval 15min
To display RX broadcast packet PMs in 24-hour intervals, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> pm show rx-bcast-packets interval 24hr
To display RX multicast packet PMs in 15-minute intervals, go to interface view for the interface
and enter the following command:
eth type eth [x/x]> pm show rx-mcast-packets interval 15min
To display RX multicast packet PMs in 24-hour intervals, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> pm show rx-mcast-packets interval 24hr
To display Layer 1 RX PMs, in bytes per second, in 15-minute intervals, go to interface view for the
interface and enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer1 interval 15min
To display Layer 1 RX PMs, in bytes per second, in 24-hour intervals, go to interface view for the
interface and enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer1 interval 24hr
To display Layer 2 RX PMs, in bytes per second, in 15-minute intervals, go to interface view for the
interface and enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer2 interval 15min
To display Layer 2 RX PMs, in bytes per second, in 24-hour intervals, go to interface view for the
interface and enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer2 interval 24hr
To display TX packet PMs in 15-minute intervals, go to interface view for the interface and enter
the following command:
eth type eth [x/x]> pm show tx-packets interval 15min
To display TX packet PMs in 24-hour intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show tx-packets interval 24hr
To display TX broadcast packet PMs in 15-minute intervals, go to interface view for the interface
and enter the following command:
eth type eth [x/x]> pm show tx-bcast-packets interval 15min
To Next Page
Loading...
Need help?
General
