Cambium Networks PTP 820C User Manual

Chapter 2: Getting Started
Changing the Management IP Address
phn-3963_004v000
Page 2-9
Changing the Management IP Address
Related Topics:
 Defining the IP Protocol Version for Initiating Communications
 Configuring the Remote Unit’s IP Address
To change the management IP address of the local unit:
1. Select Platform > Management > Networking > Local. The Local Networking Configuration
page opens.
Figure 9 Local Networking Configuration Page
2. Optionally, in the Description field, enter descriptive information about the unit.
3. In the IP address field, enter an IP address for the unit. You can enter the address in IPv4
format in this field, and/or in IPv6 format in the IPv6 Address field. The unit will receive
communications whether they are sent to its IPv4 address or its IPv6 address.
4. In the Subnet mask field, enter the subnet mask.
5. Optionally, in the Default gateway field, enter the default gateway address.

Cambium Networks PTP 820C Specifications

General

Category	Network Router
Management Interface	Web GUI, SNMP, CLI
Max Range	Up to 120 km
Ethernet Ports / Interfaces	2 x 10/100/1000 Mbps
Security	AES encryption
Operating Temperature	-40°C to +60°C
Ingress Protection	IP67
Frequency Bands	6, 7, 8, 10, 11, 13, 15, 18, 23, 26, 28, 32, 38, 42 GHz
Modulation	QPSK to 4096QAM