Cambium Networks PTP 820C User Manual

Chapter 19: Ethernet Protocols (CLI)
Configuring LLDP (CLI)
phn-3963_004v000
Page 19-384
 Tx Credit Max - The maximum number of consecutive LLDPDUs that can be transmitted at any
one time. In this release, the Tx Credit Max is set at 5.
 Message Fast Tx - The interval, in seconds, at which LLDP frames are transmitted during fast
transmission periods, such as when the unit detects a new neighbor. In this release, this
parameter is set at 1.
 Message Fast Init - The initial value used to initialize the variable which determines the number
of transmissions that are made during fast transmission periods. In this release, this parameter
is set at 4.
Configuring LLDP Port Parameters (CLI)
This section explains how to enable LLDP per port, and determine how LLDP operates and which
TLVs are sent for each port:
To define how the LLDP agent operates on a specific port, enter the following command in root
view:
root> ethernet lldp agent-admin-set interface eth slot <slot> port <port>
agent-admin <agent-admin>
To enable or disable LLDP notifications to the NMS on a specific port, enter the following
command in root view:
root> ethernet lldp agent-notif-enable interface eth slot <slot> port
<port> agent-notif-enable <agent-notif-enable>
Table 189 LLDP Port CLI Parameters
Parameter
Input Type
Permitted Values
Description
slot
Number
1
The slot in which the card resides.
port
Number
1-3
The port for which you want to
configure LLDP.

Cambium Networks PTP 820C Specifications

General

Brand	Cambium Networks
Model	PTP 820C
Category	Network Router
Language	English