Chapter 3: Configuration Guide
Configuring a Link Using the Quick Configuration
Wizard
phn-3963_004v000
Page 3-13
Figure 37 2 + 0 Multi Carrier ABC Quick Configuration Wizard – Radio #2 Selection Page
6 In the Radio #2 Interface field, select the second radio interface for the group.
7 Click Next. The Radio XPIC Configuration page opens. If you want to set up an XPIC
configuration, select the radio pair. For full instructions on configuring XPIC, including
antenna alignment instructions, see Configuring XPIC.
Figure 38 2 + 0 Multi Carrier ABC Quick Configuration Wizard – Radio XPIC Configuration Page
8 Click Next. The Radio Parameters Configuration page opens. You can configure the basic
radio parameters for each interface. If you selected XPIC in the Radio XPIC Configuration
page, you configure the parameters for the group rather than the individual interfaces.
To Next Page
Loading...
Need help?
General
