Page 37 - Manual FA01554-EN - 01/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
ERROR MESSAGES
E1 Motor M1 calibration error
E2 Motor M2 calibration error
E3 Encoder signal not detected error
E4 Service test failure error
E7 Operating time error
E9 Consecutive obstacles detected during closing
E10 Consecutive obstacles detected during opening
E11 Maximum number of obstacles
E12 Motor supply voltage missing or insu cient
E15 Incompatible transmitter error
E17 Wireless system communication error
E18 Wireless system not confi gured error
FINAL OPERATIONS
Before closing up the casing, check that the cable inlets are sealed to stop insects getting in and to prevent
damp.
To Next Page
Loading...
Need help?
General
