Canon DC10 - Selecting the Media for the Still Images

36
 When the subject is too bright, “OVEREXP.” starts flashing. In such case, use
the optional FS-H27U ND filter.
 In order to save power when the camcorder is powered by a battery pack, the
camcorder will automatically shut off if left without any operations for 5 minutes
( 84). “ AUTO POWER OFF” appears 30 seconds before shutoff. To
continue recording, turn the power switch to OFF and then back to CAMERA.
Selecting the Media for the Still Images
You can record still images on the memory card or the disc. The default media for still
images is the memory card.
1. Set the camcorder to record or view still images ( or
).
2. Press the MENU button. Using the omni selector ( ) select the
[SYSTEM SETUP] menu and press ( ).
3. Select ( ) the [MEDIA SEL. ] option and press ( ).
4. Change ( ) the setting to [DISC] or [CARD] and press ( ) to save
the selection and close the menu.
When recording, the operating mode symbol will change to (DISC STILLS) or
(CARD STILLS), depending on the media selected. In playback mode, the operating
mode symbol will change to (DISC STILLS) or (CARD STILLS), respectively.