7
Holding the Roll Holder flange (a), remove the holder
from the Roll Holder Slot.
Note
• For instructions on removing the Roll Holder from rolls, see "Removing the Roll Holder from
Rolls." ➔P.347
8
Lower the Ejection Guide and close the Top Cover.
Note
• To load new paper in the printer at this point, see "Loading Rolls in the Printer." ➔ P.339
• Clean inside the top cover before loading paper.
(See "Cleaning Inside the Top Cover.") âž” P.564
Removing the Roll Holder from Rolls
Removing the Roll Holder from Rolls
1
Lift the Holder Stopper lever (a) from the shaft side to
unlock it. Holding the Holder Stopper at the position in-
dicated (b), remove it from the Roll Holder.
iPF8400SE
Removing the Roll Holder from Rolls
User's Guide
Handling and Use of Paper Handling rolls
347
To Next Page
Loading...
Need help?
General