To Next Page

To Previous Page

Mac OS Settings

Configuring the Destination in TCP/IP Networks ............................................................................................. 492

Configuring the Destination for Bonjour Network ...........................................................................................492

Configuring the Destination for AppleTalk Networks .................................................................................... 492

Configuring the Printer's AppleTalk Network Settings ................................................................................... 494

Configuring the Destination in TCP/IP Networks

If you use the printer in a TCP/IP network, register the printer in Print & Scan (or Print & Fax) in the Mac OS

System Preferences.

Note

• For details on how to register a printer using a TCP/IP network, see the OS User Manual.

Important

• If you use the printer in a TCP/IP network, make sure the printer's IP address is configured correctly. (See

"Configuring the IP Address Using the Printer Control Panel.") ➔ P.477

Configuring the Destination for Bonjour Network

If you use the printer in a network that uses the Bonjour function, register the printer in Print & Scan (or Print &

Fax) in the Mac OS System Preferences.

Note

• For details on how to register a printer using Bonjour, see the OS User Manual.

Important

• Bonjour and IP Print (Auto) do not support printing to a printer on other network groups that require a router for

connection. Make sure the computer and printer are on the same network. For information about network set-

tings, ask your network administrator.

• By default, Bonjour is activated on the printer. You can activate or deactivate the Bonjour function or change the

printer name by using RemoteUI. For instructions on changing it, see "Using RemoteUI." ➔ P.475

Configuring the Destination for AppleTalk Networks

To print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.

Activating AppleTalk on the printer

Important

• By default, the AppleTalk protocol is disabled on the printer.

On the Tab Selection screen of the Control Panel, press ◀ or ▶ to

select the Settings/Adj. tab ( ).

Note

• If the Tab Selection screen is not displayed, press the Menu button.

Press the OK button.

The Set./Adj. Menu is displayed.

Press ▲ or ▼ to select Interface Setup, and then press the OK button.

Configuring the Destination in TCP/IP Networks

iPF8400SE

User's Guide

Network Setting Mac OS Settings

492

Canon iPF8400SE imagePROGRAF User Manual

Questions and Answers: