2
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to
select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
4
Press â–² or â–¼ to select Test Print, and then press the OK button.
5
Press â–² or â–¼ to select Interface Print, and then press the OK button.
Confirming Interface Print information
The following information is included in the Interface Print report.
Canon imagePROGRAF iPFxxxx Interface Print Printer model
Firm Firmware Version
Boot Boot ROM Version
MIT(DBF) MIT Database Format Version
MIT(DB) MIT Database Version
S/N Printer serial number
Date The date when the interface setup print report
was printed.
EOP Timer Specify the timeout period before cancellation of
print jobs that cannot be received by the printer.
TCP/IPv4 Frame Type IPv4 settings values.
Use DHCP
Use BOOTP
Use RARP
Enable DNS Dynamic Update
Use Zeroconf Function
IP Address
Subnet Mask
Gateway Address
LPD Printing
IPP Printing
IPP Printer URI
RAW Printing
Raw Mode Bi-direction
FTP Printing
WSD Printing
Use Discovery
iPF8400SE
Printing Interface Setting Reports
User's Guide
Control Panel Printer Menu
457
To Next Page
Loading...
Need help?
General