LASER CLASS 730i/720i/710 Chapter 4: Maintenance and Service
4-21
• Service error code
No. Tx or Rx Definition
##0100 [TX ] The number allowed for retransmission of the procedure signal
was exceeded during transmission
##0101 [TX/RX] The modem speed of the machine does not match that of the
other party
##0102 [TX ] Fallback is not possible
##0103 [RX ] EOL cannot be detected for 5 sec (15 sec if CBT)
##0104 [TX ] RTN or PIN has been received
##0106 [RX ] The procedure singal cannot be received for 6 sec while in wait
##0107 [RX ] The transmitting machine cannot be use fallback
##0109 [TX ] After transmitting DCS, a signal other than DIS, DTC, FTT,
CFR, and CRP was received, exceeding the permitted number of
transmissions of the procedure signal
##0111 [TX/RX] Memory error
##0114 [RX ] RTN was transmitted
##0116 [TX/RX] During a communication, suspension of loop current was
detected
##0200 [RX ] During image reception, a carrier is not detected for 5 sec
##0201 [TX/RX] DCN was received through a non-normal procedure
##0220 [TX/RX] System error (e.g., main program may have gone away)
##0223 [TX ] The line was disconnected during communication
##0224 [TX/RX] Fault occurred in the communication procedure signal
##0229 [RX ] The recording system became locked for 1 min
##0237 [RX ] The IC used to control the decoder malfunctioned
##0238 [RX ] The unit used to control recording malfunctioned
##0261 [TX/RX] System error occurred between the modem and system control
board
##0280 [TX ] The number of re-transmissions of the procedure signal has been
exceeded
##0281 [TX ] The number of re-transmissions of the procedure signal has been
exceeded
##0282 [TX ] The number of re-transmissions of the procedure signal has been
exceeded
##0283 [TX ] The number of re-transmissions of the procedure signal has been
exceeded
##0284 [TX ] DCN has been received after transmission of TCF
##0285 [TX ] DCN has been received after transmitting EOP
##0286 [TX ] DCN has been received after transmitting EOM
##0287 [TX ] DCN has been received after transmitting MPS
##0288 [TX ] After transmitting EOP, a signal other than PIN, PIP, MCF,
RTP, or RTN was received
##0289 [TX ] After transmitting EOM, a signal other than PIN,PIP,MCF,
RTP, or RTN was received
manuals4you.commanuals4you.com
To Next Page
Loading...
