5-30
Printing Environment Settings
5
SETUP Menu Settings
INTERFACE MENU Options
I/F CONNECTION
USB...................................... ON*, OFF
NETWORK........................... ON*, OFF
Specifies the settings for the interfaces used for communication with the
computer, etc.
You can specify ON or OFF for each interface.
Even if multiple interfaces are set to ON, the printer automatically switches to the
one that received the data first. Therefore, you do not need to change the setting
in the printer each time you connect the printer to different types of interfaces at
the same time.
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
MODE TIMEOUT
OFF, 5 to 300 seconds; 15 seconds*
Specifies the function to finish a job automatically.
If you specify the time the printer times out in this item, the printer can finish a job
automatically when the specified time has elapsed since no data is entered.
If this item is specified, the printer can output paper automatically when data is
remaining in the printer because of an application not sending the command to
output paper.
When OFF is specified, the printer does not use the function to finish a job
automatically.
IMPORTANT
If the function to finish a job automatically is specified, the a job may be finished in
the middle of the process when the computer takes a long time to process the data.
In this case, adjust the time the printer times out.
NOTE
•
The Job indicator on the control panel is on or blinking during a job.
•
When the printer is offline, the printer does not use the function to finish a job
automatically.
To Next Page
Loading...
