<Ink absorber counter setting>
Set the ink absorber counter value to a new EEPROM after the logic board is replaced in servicing.
1) Before replacement of the logic board, check the ink absorber counter value in EEPROM information print.
2) In the ink absorber counter setting mode, press the Stop/Reset button the specified number of time(s) according to the ink absorber
whose counter value should be transferred to the replaced new EEPROM.
3) Press the ON/OFF button to proceed to the next step.
4) The ink absorber counter value can be set in 10% increments by pressing the Stop/Reset button. Press the Stop/Reset button the
appropriate number of time(s) to select the value which is closest to the actual ink absorber counter value.
5) Press the ON/OFF button to set the selected value to the EEPROM. Print EEPROM information to confirm that the value is
roperly set to the EEPROM.
Time(s) Ink absorber Remarks
0 times Main ink absorber Reset to 0%
1 time Borderless-print ink absorber Reset to 0%
2 times Both the main and borderless-print ink absorbers Reset to 0%
3 times or
more
Not valid
Press the ON/OFF button to return to the ink
absorber counter setting mode.
Time(s) Ink absorber counter value to be set (%)
0 times 0%
1 time 10%
2 times 20%
3 times 30%
4 times 40%
5 times 50%
6 times 60%
7 times 70%
8 times 80%
9 times 90%
10 times or more
Not valid.
Press the ON/OFF button to return to the ink absorber counter setting
mode.
To Next Page
Loading...
