Canon MX700 - Service Call Errors; Error Conditions

2-2. Service Call Errors (by Cyclic Blinking of Alarm and Power LEDs)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink, and the corresponding error code is
displayed on the LCD.
absorber is replaced.
The connected digital
camera or digital video
camera does not support
Camera Direct Printing.
[2001] The device may be incompatible.
Remove the device and check the
manual supplied with the connected
device.
Remove the cable between the camera and the
machine.
The remaining ink
amount unknown.
[1683] (Applicable ink tank icon)
The remaining level of the following
ink cannot be correctly detected.
Replace the ink tank. (U130)
An ink tank which has once been empty is installed.
Replace the applicable ink tank with a new one.
Printing with a once-empty ink tank can damage the
machine.
To continue printing without replacing the ink tank(s),
press the Stop/Reset button for 5 sec. or longer to
disable the function to detect the remaining ink
amount. After the operation, it is recorded in the
machine EEPROM that the function to detect the
remaining ink amount was disabled.
Ink tank not recognized. [1684] The following ink tank cannot be
recognized. (U140)
(Applicable ink tank icon)
A non-supported ink tank is installed (the ink tank
LED is turned off). Install the supported ink tanks.
Ink tank not recognized. [1410
to
1419]
The following ink tank cannot be
recognized. (U150)
(Applicable ink tank icon)
A hardware error occurred in an ink tank (the ink tank
LED is turned off). Replace the ink tank(s).
Scanning unit (printer
cover) open.
[1200] Cover is open. Close cover. Close the scanning unit (printer cover).
Non-supported hub [2002] An unsupported USB hub is
connected. Remove the hub.
Remove the applicable USB hub from the PictBridge
(USB) connector.
No ink (no raw ink). [1688] The following ink has run out.
Replace the ink tank. (U163)
(Applicable ink tank icon)
Replace the empty ink tank(s), and close the scanning
unit (printer cover).
Printing with an empty ink tank can damage the
machine.
To continue printing without replacing the ink tank(s),
press the Stop/Reset button for 5 sec. or longer to
disable the function to detect the remaining ink
amount. After the operation, it is recorded in the
machine EEPROM that the function to detect the
remaining ink amount was disabled.
Cycles of
blinking of
Alarm and
Power LEDs
Error
Error
code
Conditions
Solution
(Replacement of listed parts,
which are likely to be faulty)
2 times Carriage error [5100] An error occurred in the carriage
encoder signal.
- Carriage unit (QM3-2650)
- Timing slit film (QC2-5687)
- Logic board (QM3-2834)
- Carriage motor (QK1-1500)
3 times Line feed error [6000] An error occurred in the LF encoder
signal.
- Timing sensor unit (QM3-
2572)
- Timing slit disk film (QC1-
9597)
- Feed roller (QL2-2206)
- Logic board (QM3-2834)
- Paper feed motor (QK1-3849)
4 times Purge cam sensor error [5C00] An error occurred in the purge unit. - Purge unit (QM3-2651)
5 / 41