(11) PTT Parameter mode
11-1) FAX PTT parameter mode
Enter the PTT parameter mode from the user mode, but not from the service mode.
How to enter the PTT parameter mode:
1) In the user mode, press the SCAN button to enter the scan mode.
2-a) Press #, 9, 7, 6, 9, # to enter the PTT parameter mode.
2-b) Press #, 9, 7, 6, 8, # to print the PTT parameter setting value.
How to finalize the data:
Press the OK button to finalize the data and press the Stop/Reset button to save the data.
How to finish the PTT parameter mode:
Press the ON/OFF button to save the specified data in the EEPROM and turn off the machine.
11-2) How to enter the PTT parameter mode
1. In the user mode, press the SCAN button to enter the scan mode and press #, 9, 7, 6, 9, #.
2. The following message is displayed on the LCD.
BIT SWITCH menu
3. Each time the right or left arrow key is pressed, the menu is changed.
NUMERIC PARAM. menu
Note: Not used in servicing.
Note: Not used in servicing.
Note: Not used in servicing.
Note: Not used in servicing.
4. Press the OK button after ?g#1 BIT SWITCH?h or ?g#2 NUMERIC PARAM.?h is displayed to enter each mode.
PTT PRAMETER
#1 BIT SWITCH
PTT PRAMETER
#2 NUMERIC PARAM.
PTT PRAMETER
#3 FAX TYPE
PTT PRAMETER
#4 NCU
PTT PRAMETER
#5 PTT SPECIAL
PTT PRAMETER
#6 FAX TEST
To Next Page
Loading...
