Care
2999828 - 05/18 - EHG-0012-00EN
103
11
Leave the water taps open until the mixture of water and cleaning agent
has reached the drain.
Close all water taps.
Flush the toilet several times.
Allow the cleaning agent to act in accordance with the manufacturer's
instructions.
Empty the water system. Collect the mixture of water and cleaning agent
for correct disposal.
For rinsing fill the entire water system with drinking water and empty
again several times over.
11.4.3 Disinfecting the water system
Only use suitable disinfectants as sold by the specialist trade.
The disinfectant must meet national regulations and be approved (if re-
quired).
Collect any emerging mixture of water and disinfectant for correct dis-
posal.
When disinfecting the water system, proceed the same way as when clean-
ing the water pipes (see section 11.4.2). Simply use disinfectant instead of
cleaning agent.
11.4.4 Cleaning the waste water tank
Clean the waste water tank after every use.
Empty the waste water tank.
Open the cleaning opening on the waste water tank and the drain cock.
Thoroughly rinse out the waste water tank with fresh water.
If possible, clean waste water sensors through the cleaning opening by
hand.
To Next Page
Loading...
Need help?
General