Living
2999828 - 05/18 - EHG-0012-00EN
43
6
6.6.2 Folding worktop
The folding worktop is designed only for minimal loads (e.g. kitchen
utensils). Do not use the folding worktop as a repository for heavy ob-
jects.
1 Magnet
2 Worktop
3 Holder
Fig. 24 Folding worktop (driving posi-
tion)
To increase the size of the kitchen work surface, a folding worktop can be
folded out at the side of the kitchen counter.
Fold worktop (Fig. 24,2) up.
Lock worktop. In order to do this, swivel out the holder (Fig. 24,3).
Swivel holder (Fig. 24,3) away.
Fold worktop (Fig. 24,2) down.
A magnet (Fig. 24,1) holds the worktop in driving position.
6.7 PVC-floor covering
Gas pipes and electric lines are laid in the floor. Never drill holes in
the floor or insert any screws. That could cause a gas explosion, an
electrical shock or a short circuit due to damage to a cable.
Shoes with pointed heels can leave permanent impressions in the PVC-
floor covering. Never wear shoes with pointed heels in the vehicle.
Rubber mats or long exposure to ketchup, carrot juice, ink, blood or lip-
stick can discolour the PVC-floor covering. If possible, remove stains
from the floor immediately.
6.8 Lamps
The light switches have different layouts according to the model. The
light switches are located either in the entrance area, directly on the cor-
responding lamp or next to the lamp, e.g. in the vicinity of the seating
group.
The light switches for the lamps on the ceiling of the living area are installed
in the rear area and in the entrance area (at the sliding door).
Bringing the folding worktop
into the work position:
Bringing the folding worktop
into the travel position:
To Next Page
Loading...
Need help?
General