Appliances
2999828 - 05/18 - EHG-0012-00EN
79
9
The domestic water container can be supplied with water from the water
tank.
Switch on the 12 V power supply on the panel.
Close the safety/drainage valve. Turn the knob (Fig. 60,1) perpendicular
to the safety/drainage valve and push the push button (Fig. 60,2) in.
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
Keep the water taps open until the water flowing out of the water taps
has no bubbles in it. This is the only way to ensure that the domestic
water container is full of water.
Close all water taps.
Set the rotary switch (Fig. 59,6) on the operating unit (Fig. 59) to "
".
Open the safety/drainage valve. To do this turn the knob (Fig. 60,1) par-
allel to the safety/drainage valve. The push button (Fig. 60,2) jumps out.
The domestic water container is emptied to the outside through the
safety/drainage valve.
Check whether the water has been drained completely from the domes-
tic water container (approx. 12 litres).
Further information can be obtained in the manufacturer's instruction
manual.
9.2.3 Heater and production of hot water (Truma Combi D)
The heater and production of hot water Truma Combi D is operated with die-
sel.
The functions and the operation is the same as in the case of the heater
Truma Combi operated with gas, see section 9.2.2.
See the manufacturer's documentation for further information.
Filling/emptying domestic
water containe
To Next Page
Loading...
Need help?
General