Before the journey
2999828 - 05/18 - EHG-0012-00EN
21
3
3.4 Entrance step
Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
Do not step on the entrance step until it has extended completely.
There is a risk of injury!
Do not under any circumstances raise or lower persons or loads with
the entrance step.
The rocker switch to operate the entrance step is installed on the bottom
right in the area of the sliding door.
If the entrance step has not been properly retracted and locked into
place, a warning tone is heard when the ignition is switched on.
The vehicles have a one-step, electrically extendable entrance step.
Fig. 1 Operating switch entrance
step
Before stepping on the entrance step, fully extend it.
Press the rocker switch (Fig. 1,1) down until the entrance step has ex-
tended completely.
Press the rocker switch (Fig. 1,1) up until the entrance step has re-
tracted completely.
If the entrance step does not retract electrically due to a defect, it must be
pushed in by hand and secured against sliding out.
The entrance step may only be moved by hand when the drive rods
have been released.
Extending:
Retracting:
Emer
To Next Page
Loading...
Need help?
General