Cardinal 708 - Annunciators

17
ANNUNCIATORS
Note that annunciators are turned on to indicate that the display is in the mode corresponding to the
annunciator label or that the status indicated by the label is active. Some annunciators are flashed
on and off to signal that the 708 is waiting for an input from the keypad for use by the feature indi-
cated by the annunciator.
ZERO
The ZERO annunciator is turned on to indicate that the weight is within +/- 1/4 division of the center
of zero.
GROSS
The GROSS annunciator is turned on to indicate that the displayed weight is the gross weight which
is the total of all weight placed on the scale platform since the display was last reset to zero.
TARE
The TARE annunciator is flashed on and off to show that the 708 is in the tare weight input mode
and that the new tare weight value should be entered on the numeric keys.
NET
The NET annunciator is turned on to show that the displayed weight is the net weight which is the
gross weight less the tare weight.
PWC1
The PWC1 annunciator is turned on to indicate that the displayed weight is equal to or greater than
the weight value stored as preset number 1. Note that this annunciator is active only when the
Preset Weight Comparator feature has been enabled.
PWC2
The PWC2 annunciator is turned on to indicate that the displayed weight is equal to or greater than
the weight value stored as preset number 2. Note that this annunciator is active only when the
Preset Weight Comparator feature has been enabled.
STABLE
The STABLE annunciator is identified with two small triangular shapes and is turned on when the
weight display is stable. This means that the change in successive weight samples is less than the
motion limits selected during setup and calibration of the 708.
UNDER
The UNDER annunciator is located to the left of the weight display and is used to signal that the
displayed weight is less than the minimum value of acceptable weight used in the Checkweigher
feature. Note that this annunciator is active only when the Checkweigher feature is enabled.
ACCEPT
The ACCEPT annunciator is located just above the weight display and is used to signal that the
displayed weight is within the acceptable weight limits for the Checkweigher feature. That is, it is
equal to or greater than the minimum acceptable weight and equal to or less than the maximum
acceptable weight. Note that this annunciator is active only when the Checkweigher feature has
been enabled.
OVER
The OVER annunciator is located to the right of the weight display and is used to signal that the
displayed weight is equal to or greater than the minimum value of over weight used in the
Checkweigher feature. Note that this annunciator is active only when the Checkweigher feature has
been enabled.
lb
The lb annunciator is located to the right of the weight display and is turned on to show that the
displayed weight units of measure is pounds.
kg
The kg annunciator is located to the right of the weight display and is used to signal that the units of
measurement for the displayed weight is kilograms.