Carimali BlueDot - Hydraulic Circuit Filling

3.4
 3.1.4 Hydrauliccircuitlling
Machine with tank version
ATTENTION
Switchthemachineoffrstanddisconnect
the power cable.
Open the front door and remove the water
tank.
Fill the tank with water up to the MAX level.
Insert the full tank into the machine and
close the lower, front door.
Connect the power cable and position the
switching on button on the position “I” to
switch the machine on.
Waituntilthermwareisloadedandfollow
the procedure on the display.
B
C
Water tank
Water tank
Switching on button