30
6.2. Installation
Touch INSTALLATION to perform the start-up process in order to learn
all equipment in system. Select FULL INSTALLATION, then touch
NEXT to initiate the process.
Touch Airflow Verification Test to perform a duct assessment. This can
be done if duct modifications have been made since installation of the
Infinity System Control. Duct assessment can be performed without
performing a full system install.
NOTE: For Small Packaged Products (SPP), please use the following
instructions for Set-up (Set-Up Section), Checkout (Checkout Section),
and Service (Service Information Section):
– For PAC AC Indoor and OAC HP Indoor, follow Fan Coil
instructions.
– For Gas PAC Indoor and Gas PHP Indoor, follow Furnace
instructions.
– For all PAC Outdoor, follow AC/Heat Pump instructions.
6.3. Set up
A13130
NOTE: Depending upon the equipment installed, the following options
will be displayed. See the Infinity System HVAC equipment Installation
Instructions for more details, as provided.
• Indoor:
To Next Page
Loading...
