EasyManua.ls Logo

Carter CT12 - Page 23

Carter CT12
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
20
(a) Before driving the machine to confirm the position of the
lower part of the vehicle body and operation
Personnel relations:
If the motor running beneath the cabin, when forward brake
pedal / lever, the machine will move backward.
When the guide wheel is located under the cabin, to move
forward the brake pedal/ lever, the machine will move forward.
(b) In the lower portion of the vehicle body inner side of the
machine, paste with directions card. When the operator move
forward the pedal / lever, the head pointing ways of the signs
arrows is the actual direction of travel of the machine.
Walking pedal / lever mishandling can cause serious injury or death.
4. Walking safety rules
(a)When using the machine, in order to prevent the stall due to an
overload stall and to avoid the loss of working device, do not
exceed the most of the machine allowable load or performance.
(b) when walking on flat ground, to recover the working device
and keep the ground height of 40-50cm (16-20in).
(c) when walking on rough ground, walking to idle, and does not
to swerve, otherwise the machine will have to overturn. When the
working device hit the ground, the machine out of balance, or
would bad machines or structure.
(d)When walking over rough terrain or on steep slopes, if the
machine is installed down speeding device, switch off(take off)
the automatically downshift. If the automatic deceleration switch
is turned on, the engine speed will mention high, walking speed
suddenly accelerated.
(e) As far as possible, avoid walking on obstacles, if the machine
had to walk on the obstacles, to make the device close to the
ground and low-speed walking. Do not cause the machine to
violent tendencies walking on the side of the obstacle.
(f) When walking or operation, must be with people, buildings, or
other machines to maintain a safe distance to avoid contact with
them.
(g) When passing on from bridges or buildings, to first check
whether the structural strength sufficient to support the weight of
the machine.
(h) When walking on the road, first of all the relevant authorities

Table of Contents