SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
21
to check and follow their guidance.
(i) When in the tunnel, bridge, wire or other highly limited
operation to slow the operation, and to pay special attention not to
let the working device to come into contact with any thing.
5. Driving machine safely
(a) Before moving the machine, make sure the direction of travel
and how to move step board or joystick.
(b) Pressing the front portion of the pedal walking or forward
implementation of walking poles, so that the machine
Move towards the guide wheel. (On the right track operation,With
reference to the pedal, the operating lever to the part of the driving
machine )
(c) Walking in the slope may cause the machine to slip or tip over,
resulting in serious injury or death.
(d) The slope walking, keep away from the ground to make the
working device 20-30cm (8-12in). In case of emergency, you can
quickly drops the work apparatus on the ground in order to help
anchor the machine.
(e) When walking uphill,transferred the the cabin facing the uphill
direction.When walking downhill,transferred the the cabin facing
the downhill direction..
(f) When walking, be sure to check the hardness of the ground in
front of the machine.
(g) when walking on steep slopes, Stretch the working device in
front ,in order to improve balance, keep the distance from working
device to the ground 20-30cm(8-12in) and low-speed traffic.
(h) when going downhill,reduce the engine speed, keep the travel
lever maintained at a position close to the "median", and walking
at a low speed.
(j) Do not turn on slopes or across the slope. Be sure the next to a
flat place to change the location of the machine, and then on the
ramp slope.
(k) To the low-speed walking on the grass, leaves or wet steel,The
machines also have a risk of slipping, even in the case of a small
slope.
(l) If the engine is turn off when the machine is walking on the
ramp, move the joystick to the "median",and then restart the
engine.
To Next Page
Loading...