SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
22
Notes on slopes
The machine has the potential to tip over on rough terrain or
slopes. To prevent rollover accidents, when operating on
uneven ground or slopes:
Slow down the engine.
Choose low-speed walking mode.
Operate the machine slowly and pay attention to the
movement of the machine.
Never attempt to walk on a slope with a bucket loaded
with material or with a suspended object.
When the slope angle exceeds 25 degrees, will cause the
engine lubrication insufficient.
6. To prevent the machine out of control causing injury
(a) when the machine should parked on the level of the ground as
much as possible
(b) Do not park the machine on slopes.
Risk of serious injury!
The wrong operation may result in serious injury.
Never attempt to go up or down a slope with a gradient greater than 30 ° , and never attempt to cross a slope with
a gradient greater than 15 ° .
Be sure to fasten your seat belt.
Don't try to turn on the slope. The machine may slip or tip over. You can turn only on very gentle, solid slopes.
Try to avoid crossing slopes where the machine may slip or tip over.
Avoid turning onto the ramp. Never try to turn onto the ramp. The machine may tip over. If you must turn
downhill, carefully operate the loading and arm at low speed.
If the engine stalls on a ramp, immediately lower the bucket to the ground, return the levers to neutral position,
and restart the engine.
Be sure to warm up the machine fully before going up the steep slope. If the hydraulic oil is not sufficiently
preheated, it may not give full play to the performance of the machine.
To Next Page
Loading...