Carver C43 - Filling the Water Tank; Pressurizing and Priming the Water System

SyStem Operating infOrmatiOnSyStem Operating infOrmatiOn
4327 • X5 04/2015 63
It is important to ush the freshwater tanks periodically. Thoroughly ush the water system at the following intervals:
• Before initial use
• Flush and sanitize at least once each season
FILLING THE WATER TANK
The freshwater tank is lled through a deck tting with a plate labeled WATER. The plate is located on the starboard
transom deck corner.
Wa
ter
Fill
Plate
NOTE: Tank capacity may not be usable according to trim and loading. It is important to keep a 20% reserve in the
tanks at all times.
NOTICE: Never overll the water tank. Never leave the ll hose unattended while the tank is being lled. Overlling could
rupture the tank.
PRESSURIZING AND PRIMING THE WATER SYSTEM
NOTE: Pressurize and prime the water system only after the freshwater tanks are full.
1. Verify that the DC control center has power.
2. Switch ON the AUTOSUMP circuit breaker, located on the DC control center.
3. Locate the hot water tank in the engine room. The hot water tank is located forward of the STARBOARD freshwater
tank in the engine room.
a. Open the hot and cold water shut-off valves on the hot water tank.