CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA Corporation
www.cas-usa.com 15
B.LINE
NONE
LINE1
How many blank lines after strings output:
NONE=no blank line, LINE1/2/3/4=there're 1,
2,3 or 4 blank lines after strings, used for
paper feed forward 1/2/3/4 lines.
LINE1
LINE2
LINE3
LINE4
COM3* BAUD.RT
1200
9600 selection of com3's baud rate
2400
4800
9600
19200
BYT.FMT
8N1
8N1
selection of com1's byte format:
(1)8N1=8 data bits, No parity check bit, 1 stop
bit; (2)7O1=7 data bits, 1 Odd parity check
bit, 1 stop bit; (3)7E1=7 data bits, 1 Even
parity check bit, 1 stop bit; (4)7O2=7 data
bits, 1 Odd parity check bit, 2 stop bit;
(5)7E2=7 data bits, 1 Even parity check bit, 2
stop bit;
7O1
7E1
7O2
7E2
OUT.MOD
NONE
PRTCMD
Select com3 output mode: (1) NONE = No
communication ; (2)CONT=continuously output;
(3)PRINT=output after PRINT key pressed;
(4)CMD=output after a request command is
received; (5)PRT.CMD= output after PRINT key
pressed or request command received;
(6)STABLE=output after scale is stable;
Note: use PRINT or CMD to output data, the
scale must be stable.
CONT
PRINT
CMD
PRTCMD
STABLE
LAYOUT
MULTPL
MULTPL
Com3 output content and format set:
(1)MULTPL= the following selected item in
OUT3 will be output use defined format;
(2)SINGLE= only displayed content and current
status will be output, it’s compatible with
NCI-SCP01; (3) EH-SCP= Command
–response mode, similar to Toledo PS60
protocol; （4）SCP-12 = only displayed content
and current status will be output, it’s compatible
with NCI-SCP12（NCI3835）;
SINGLE
EH-SCP
SCP-12
OUT3* SCAL.ID
YES
NO
Yes/No=enable/disable output scale's ID
number, Prompt is “SCALE ID”
NO
GROSS
YES
NO
Yes/No=enable/disable output gross weight.
Prompt is “GROSS”
NO
TARE YES
NO
Yes/No=enable/disable output tare weight.
Prompt is “TARE”
NO
NET
YES
YES
Yes/No=enable/disable output net weight.
Prompt is “NET”
NO
PERCNT YES
NO
Yes/No=enable/disable output weight
percentage. Prompt is “PERCENTAGE”
NO
To Next Page
Loading...
