D. Stable class range
● Keep pressing ENTER key in USER PROGRAMMING MODE until the display
appears as below.
● There are 6 options, and Pressing MOVE key is possible to rotate among the options.
(Default setting: 1)
( 0=off, 1=0.05d, 2=0.151d, 3=0.25d, 4=0.35d,5=0.45d)
● If you want to exit, press C key to confirm and go back to normal weighing mode.
However, if you want to keep going to set other menus, press ENTER key to confirm and
move on next.
※
Please turn off the scale after setting.
E. Stable class rate
● Keep pressing ENTER key in USER PROGRAMMING MODE until the display appears as
below.
● There are 5 options, and Pressing MOVE key is possible to rotate among the options.
(Default setting: 1)
Level : 1, 2, 3, 4, 5
The larger number is more stable.
● If you want to exit, press C key to confirm and go back to normal weighing mode.
However, if you want to keep going to set other menus, press ENTER key to confirm and
move on next.
※
Please turn off the scale after setting.
To Next Page
Loading...
Need help?
General
