29
F. Backlight type
● Keep pressing ENTER key in USER PROGRAMMING MODE until the display
appears as below.
● There are 2 options, and Pressing MOVE key is possible to rotate among the options.
(Default setting: 0)
● 0 – Auto. Backlight
Backlight will be going on automatically whenever the scale is loaded by objects weigh
greater than 9 display resolution
or any of keys is pressed. And it will be going off also
automatically approx. 5 seconds after the scale returns to zero.
1 – Manual backlight
Press (decimal point) key to switch on and off backlight.
● If you want to exit, press C key to confirm and go back to normal weighing mode.
However, if you want to keep going to set other menus, press ENTER key to confirm and
move on next.
※
Please turn off the scale after setting.
To Next Page
Loading...
