CAS NT-302A - Auto Print Setting; BCD Output Selection; Average Display Setting; Tension and Compression Setting

29 / 44
Auto Print Setting
F59
●
0
Manual Mode : Print output, when 0 KEY input.
1
Auto Mode : Print Output, when Finish Relay output.
BCD output Selection
F60
●
0
Positive output
1
Negative output
Average Display setting
F63
00
00
∫
99
00 setting : Average Display mode not use
99 setting : make average every 99pcs display data and display
Steady LED Status Lamp Delay time setting
F64
00
00
∫
99
00 setting : No delay for the Steady LED lamp
99 setting : Delay during 9.9sec, and LED lamp will be ON.
Tension and Compression setting
F65
●
0
Not Use
1
Use
All function Initialize (Only for authorized personnel)
F77
Press ENTER KEY  all function will be initialized