CAS NT-302A - Error Handling and Warranty; Troubleshooting and Test Modes

40 / 44
7. Error and Treatment
1. TEST Mode
TEST Mode No.
Contents
Detail information
TEST 1.
Analogue TEST mode
TEST 2.
Keypad TEST mode
TEST 3.
SET.CAL Mode
TEST 4.
Display TEST Mode
TEST 5.
Relay output TEST Mode
TEST 6.
External input(Digital Input)TEST Mode
TEST 7.
Un-Calibrated Analogue TEST Mode
TEST 8
Function DATA setting Print Mode
Enter to TEST Mode
Turn on the power with pressing 3 KEY.
Then, display will show , then press No. key and move to the certain TEST mode.
Exit from TEST Mode
Press CLEAR KEY to exit from each TEST mode.
Then, display will show
Under TEST 3. mode, press 3 KEY to exit
TEST
TEST
SET-CAL
TEST