Case 435 - Hydraulic Pump - Remove (A.10.A.20 - F.10.A.10); 435, 445, 445 Ct

DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
Hydraulic pump - Remove (A.10.A.20 - F.10.A.10)
435, 445, 445CT
1. Loosen and remove the mounting bolts an d washers
for the floor plate and the cover. Remove the floor
plate and the cover to gain access to the hydraulic
pump.
BD04C141x 1
2. Place a shop towel under the gear pump.
3. Remove the cap from the hydraulic reservoir.
CAS1871
4. Connect a vacuum pump to the hydraulic reservoir.
CAS10192
5. Reservoir - Apply vacuum (A.10.A.22 - F.35.A.50)
Start the vacuum pump.
6. Tag and disconnect the hose from the fitting at the
suction port of the gear pump.
BD04C141x 2
7. Install a plug in the hose and a cap on the fi tting.
8. Tag and disconnect the hose from the fitting at the
pressure port of the gear pump.
9. Install a plug in the hose and a cap on the fi tting.
10. Stop the vacuum pump.
1 04/05/2005
A.10.A / 32