113
STATIC section
This section specifies parameters necessary for the integrated WLAN module to establish
connection with Access-Point.
Table 2.69
KEY VALUE
SSID Set SSID.
ADHOC Set Infrastructure or AdHoc mode selecting either value.
1: Infrastructure
0: AdHoc
WEP Set WEP to be included or not.
1: Without WEP
0: With WEP
KEYINDEX Set WEP key INDEX in the range of 0 to 3.
KEYDATA Using the WLAN Setting tool, set encrypted WEP key
data selecting either value.
20 bytes for 40-bit WEP
52 bytes for 108-bit WEP
SECURITY Set security selecting one of the values.
NONE
WEP
WPA
WPA2
AUTH Set authentication selecting one of the modes.
OPEN
PEAP
TLS
PSK
WEP_OPEN_KEYINDEX Set WEP key INDEX in Open Authentication in the range
of 1 to 4.
WEP_OPEN_KEY Set WEP key.
WPA_PEAP_USER Set user name of WPA_PEAP.
WPA_PEAP_PASS Set password of WPA_PEAP.
WPA_PEAP_DOMAIN Set domain name of WPA_PEAP.
WPA_PEAP_VALIDATESERVER Set WPA_PEAP server certificate to be valid or not
selecting either value.
0: Server certificate invalid
1: Server certificate valid
WPA_TLS_DOMAIN Set domain name of WPA_TLS.
WPA_TLS_VALIDATESERVER Set WPA_TLS server certificate to be valid or not
selecting either value.
0: Server certificate invalid
1: Server certificate valid
WPA_TLS_CERTIFICATE Set friendly name of WPA_TLS client certificate.
WPA_PSK_KEY Set WPA_PSK key length in the range of 16 to 128 bytes.
WPA2_PEAP_USER Set user name of WPA2_PEAP.
WPA2_PEAP_PASS Set password of WPA2_PEAP.
Continue.
To Next Page
Loading...
