121
2.7.2 Power ON Factors
The following is the power ON factors. These factors can be set enabled or disabled using the
System Library.
Power ON Factors
• The Power key is pressed while the power is off.
• A time period set for the Alarm function elapsed.
• The terminal is mounted on cradle while the power is being supplied by AC Adaptor via the
cradle.
• Trigger key is pressed.
• Reset switch on the back of the terminal is pressed.
The functions of the System Library relevant to the “Power ON Factors“ are as follows.
SysSetBootup
: Sets up “Enable” or “Disable” for turning on the power.
SysGetBootup
: Retrieves “Enabled” or “Disable” status for turning on the power.
Power ON Disable Factors
Factors that do not allow turning on the power are as follows.
• When the battery pack’s voltage level is not sufficient enough to start up the terminal (VDET2
level or less).
• The battery cover lock switch (at the battery compartment) is open.
To Next Page
Loading...
Need help?
General
