180
3.22 Imager Setting
This tool allows the user to change the parameters and operating modes required for reading 1D
and 2D symbologies. The changed parameters and modes are saved in ini file and become effect
automatically when the TDRead application invokes.
1D and 2D Tabs
These tabs are to set up the 1D symbologies in the 1D tab and 2D symbologies in the 2D tab
respectively. The checkboxes with check mark enable the symbologies to be read. Or, removing
the check mark disables the symbology not to be read.
Figure 3-59 Figure 3-60
To Next Page
Loading...
Need help?
General
