68
2. To set up multiple output methods effect, specify a sum of each value of the output methods
you wish to set. However, if you set “EAN128 without Full ASCII conversion”, “EAN128 with
code ID attached” and “EAN128 Fnc → GS conversion” effect at the same time, “EAN128
without Full ASCII conversion” has the priority over the other settings. Thus, the settings are
disabled.
3. Since Gun-trigger key is not integrated in the terminal, the key value is ignored.
4. A.I. is the abbreviation of Application Identifier which is attached at the forefront of bar code
of RSS-14, RSS-Limited, and RSS-14 Stacked symbologies.
5. Setting up the scan width control function in one of four modes while the setting gain is set up
in Auto mode may cause a deterioration of scanning bar codes that are printed in a poor quality.
If you need to set up the scan width control function, select the setting gain in Mode 0 to Mode
3. Or, if you select the setting gain in Auto mode, select the scan width control function in “No
control on laser beam emission width” mode only
The functions of the Laser Scanner Library relevant to the Configuration File are as follows.
OBRSaveConfigFile
: Saves all settings for the scanner driver into the configuration file.
OBRLoadConfigFile
: Retrieves and then loads the configuration file into the scanner
driver.
OBRSetDefaultSymbology
: Sets up default status of the Laser Scanner driver.