103
OTHER RECORDING FUNCTIONS
Reducing the Effects of Hand or Subject
Movement
You can reduce the effects of subject movement, and for
hand movement that tends to occur when shooting a far-
away subject using telephoto, a fast-moving subject, or
under dim lighting conditions.
1.
Perform one of the procedures below to
enable Anti Shake.
Using the BEST SHOT mode
1. In a REC mode, align the mode dial with “ ”, and
then press [SET].
2. Use [왖], [왔], [왗], and [왘] to select the “Anti Shake”
scene, and then press [SET].
Using the Menu Screen
1. In a REC mode, press [MENU].
2. Select the “REC” tab, select “Anti Shake”, and then
press [왘].
3. Use [왖] and [왔] to select “Auto”, and then press
[SET].
• (Anti Shake indicator) is displayed on the
monitor screen while Anti Shake is turned on.
2.
Press the shutter button to record the image.
IMPORTANT!
• Anti Shake is disabled automatically when any
setting other than “Auto” is selected for ISO
sensitivity. If you want Anti Shake to be operational
after turning it on, be sure to change the ISO
sensitivity setting to “Auto” (page 123).
• Recording with Anti Shake can cause an image to
appear somewhat coarser than normal and can
cause slight deterioration of image resolution.
• The Anti Shake feature may not be able to eliminate
the effects of hand or subject movement when
shaking is severe.
• Anti Shake is disabled during movie recording.
• The Anti Shake feature may not work when using a
very low shutter speed. If this happens, use a tripod
to stabilize the camera.
To Next Page
Loading...
Need help?
General
