124
Viewing Snapshots and Movies
Use the following procedure to copy an image in a group to a location outside of the
group.
1. While CS or interval shot group playback is in progress or paused,
press [2].
This will display the “Edit Group” menu.
2. Use [8] and [2] to select “Copy”, and then press [SET].
3. Use [4] and [6] to display the image you want to copy.
4. Use [8] and [2] to select “Copy”, and then press [SET].
NOTE
• The functions below cannot be performed on snapshots inside a group. Before
using either of these functions, perform the above procedure to copy the image
first.
White Balance, Brightness, Trimming, Rotation, Resize
1. In the PLAY mode, use [4] and [6] to scroll through the images until
the one you want is displayed.
2. Rotate the zoom controller towards z ([) to
zoom.
You can use [8], [2], [4], and [6] to scroll the zoomed
image on the monitor screen. Rotate the zoom controller
towards w to unzoom the image.
– When monitor screen contents are turned on, a
graphic in the lower right corner of the screen
shows what part of the zoomed image is currently
displayed.
– To exit the zoom screen, press [MENU].
– Though the maximum image zoom factor is 8X,
certain image sizes may not allow zooming up to
the full 8X.
Copying a Group Image
Zooming an On-screen Image
Image area
Current display area
Zoom factor
To Next Page
Loading...
Need help?
General
