48
Snapshot Tutorial
You can manually adjust an image’s exposure value (EV value) before shooting it.
• Exposure Compensation Range: –2.0 EV to +2.0 EV
• Unit: 1/3EV
1. In the REC mode, press [SET].
2. Use [8] and [2] to select the (EV Shift) Control Panel option, and
then press [SET].
3. Use [8] and [2] to adjust the exposure compensation value.
4. Press [SET].
This applies the exposure compensation value. The exposure compensation
value you set remains in effect until you change it or turn off the camera (which
causes it to revert to “0.0”).
NOTE
• When shooting under very dark or very bright conditions, you may not be able to
obtain satisfactory results even after performing exposure compensation.
Correcting Image Brightness (EV Shift)
[8], clockwise:
Increases the EV value. A higher EV value is
best for light-colored subjects and backlit
subjects.
[2], counterclockwise:
Decreases the EV value. A lower EV value is
best for dark-color subjects and for shooting
outdoors on a clear day.
To cancel exposure compensation, change the EV value to 0.0.
Exposure compensation value
To Next Page
Loading...
Need help?
General
