40
Snapshot Tutorial
2. Use [8] and [2] to select the setting you want to change, and then
press [SET].
This will select one of the Control Panel icons and display its settings.*
3. Use [8] and [2] to change the setting.
4. After the setting is the way you want, press
[SET].
This will apply the setting and return to the REC
mode.
NOTE
• You also can use on-screen menus to configure settings other than those listed
above (page 96).
Using the Control Panel
The Control Panel can be used to configure camera
settings.
1. In the REC mode, press [SET].
• You can also display the Control Panel by
pressing [2].
1
Self-timer (page 41)
2
White balance (page 42)
3
Focus (page 44)
4
ISO sensitivity (page 46)
5
Make-up Level (page 47)
6
EV shift (page 48)
7
Flash (page 49)
8
Metering (page 51)
* Items displayed in the Control Panel depend on the recording mode.
[SET]
[8] [2] [4] [6]
1
5
3
4
7
8
2
6
Control Panel
To Next Page
Loading...
Need help?
General
