EasyManua.ls Logo

CENTURION SYSTEMS D10 SMART - 2.2. Technical Specifications

CENTURION SYSTEMS D10 SMART
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
page 10 www.centsys.com
SPECIFICATIONSSECTION 2
2.2. Technical Specications Continued
TABLE 1 CONTINUED
TABLE 2
1. Can operate o a solar supply; consult your local dealer for assistance
2. Based on 25°C ambient temperature and unit not in direct sunlight
3. Based on a motor push force of less than 50% of rated (Starting and Running forces)
4. Gate opening and closing speeds can be congured to run slower depending on the requirements of individual installations
5. Can increase battery capacity for longer standby times
6. Based on 4m gate, excluding all accessories
7. Multiple buttons per remote can be used
8. Refer to the table below for D10 Turbo SMART’s recommended gate speed for specied gates masses
1. If a D10 Turbo SMART is used on a gate over 250Kg, the speed must be reduced according to the table above
to ensure that the gate can be safely stopped in an emergency.
2. Cenurion Systrems (Pty) Ltd recommends the use of a D10 SMART for gates weighing over 500KG.
D10 SMART D10 Turbo SMART D20 SMART
Operations in standby
(7.2Ah Batteries)
Operating Mode
Power
saving
15m/
min
15kgf
Normal
26m/
min
15kgf
Power
saving
15m/
min
9kgf
Normal
45m/
min
9kgf
Power
saving
15m/
min
20kgf
Normal
18m/
min
20kgf
Half day
3,5,6
118 63 189 130 101 55
Full day
3,5,6
93 50 150 104 80 45
Collision Sensing Electronic
Operating temperature
range
-15°C to +50°C
Onboard receiver type
Code-hopping multichannel receiver with
selective add and delete
Receiver code storage
capacity
1500 Remotes
7
Receiver frequency 433.92MHz
Degree of protection IP54
Mass of unit packed (with
standard kit, but excl. rack and
battery)
13kg 13.5kg 13kg
Packaging dimensions (with
standard kit, but excl. rack and
battery)
350mm wide
x 282mm deep
x 470mm high
Fuse Protection Type Rating
Main Control Card Serviceable 25A
Aux. Supply Resetable Fuse 24V 3A (10sec Pulse)
Charger (Mains Supply) Non-serviceable 3A slow-blow
RECOMMENDED SPEEDS AND GATE MASSES FOR THE D10 TURBO SMART
1
Max Speed (m/min) Gate Mass (Kg) Max Speed (m/min) Gate Mass (Kg)
45 250 29 600
2
41 300 27 700
2
36 400 25 800
2
32 500 24 900
2
23 1000
2

Table of Contents

Related product manuals