CENTURION SYSTEMS VANTAGE - Installation Handover Procedures

page 72 www.CentSys.com
29. Installation Handover
Once the installation has been successfully completed and tested, it is important for the
installer to explain the operation and safety requirements of the system.
NEVER ASSUME THE USER KNOWS HOW TO SAFELY OPERATE AN AUTOMATED
GATE!
Even if the user has used one before, it does not mean he knows how to SAFELY operate
it. Make sure that the user fully understands the following safety requirements before
nallyhandingoverthesite.
The following needs to be understood by the user:
• How to operate the manual release mechanism. (Show them how by demonstration)
• How the obstruction detection and all other safety features work. (Show them how by
demonstration)
• Allthefeaturesandbenetsoftheoperator,i.e.Beams,etc.
• All the safety considerations associated with operating an automated gate. The user
should be able to pass this knowledge on to all other users of the automated system and
must be made aware of this responsibility.
• Do not activate the gate operator unless you can see it and can determine that
its area of travel is clear of people, pets, or other obstructions
• NOONEMAYCROSSTHEPATHOFAMOVINGGATE.Alwayskeeppeopleand
objects away from the gate and its area of travel
• NEVERLETCHILDRENOPERATEORPLAYWITHTHEGATECONTROLS,anddo
not allow children or pets near the gate area
• Becarefulwithmovingpartsandavoidcloseproximitytoareaswherengers
or hands could be pinched
• Securealleasily-accessiblegateoperatorcontrolsinordertoprevent
unauthorised use of the gate
• Keep the automated gate system properly maintained, and ensure that all
workingareasarefreeofdebrisandotherobjectsthatcouldaectthegate
operation and safety
• On a monthly basis, check the obstruction detection system and safety devices
for correct operation
• All repair and service work to this product must be done by a
suitablyqualiedperson
• This product was designed and built strictly for the use indicated
in this documentation. Any other use, not expressly indicated here, could
compromise the good condition/operation of the product and/or be a source of
danger!
Centurion Systems (Pty) Ltd does not accept any liability caused by improper use of
the product, or for use other than that for which the automated system was designed.
Ensure that the customer is in possession of the User Guide and that you have
completed the installation details in the back of the User Guide.
SECTION 29 INSTALLATION HANDOVER