CENTURION SYSTEMS VANTAGE - Electrical Setup Procedures

page 10 www.CentSys.com
3. Electrical Setup
1. Always check that the circuit breaker in the electrical panel is in the OFF position,
andthatallhigh-voltagecircuits(morethan42.4V)arecompletelyisolatedfromthe
mains supply before doing any work.
2. Ensurethatalllow-voltagesystems(lessthan42.4V)aresuitablyprotected
from damage, by disconnecting all sources of power such as chargers and
batteries before doing any work.
3. All electrical work must be carried out according to the requirements of all applicable
local electrical codes.
3.1. Secure V-Series
Wall Box to Wall
SecuretheV-SeriesWallBox
to the wall using the most
appropriate means.
Be sure to position the Wall Box
so as not to cause any hazards
during and after the installation.
Preferably mount the Wall Box:
FIGURE 1
Mount the V-Series Wall Box preferably at
a comfortable working height
3.2. Connect all Wiring
Connect all the required cables to
the Controller; see pages 16 to 33.
• Out of direct sunlight
• At a comfortable
working height
• Away from garden
sprinklers, etc.
• To allow easy access
even when the gate is
open
FIGURE 2
SECTION 3 ELECTRICAL SETUP