CE+T Power T2S-ETH User Manual

35 – Monitoring T2S - ETH User Manual – v1.4
Graphical User Interface
• SNMP Traps
 Traps can be enabled for
different events and alarms
under this section. Trap
receiver configuration has
to be done under SNMP
tab.
 Test Traps can also
verified.
7.4.10.3 SNMP
• SNMP
SNMP configuration can be done
from T2S ETH web page when
logged in as expert login.T2S
ETH when used as a standalone
communication card it only
supports SNMP V1. When T2S
ETH is connected to Catena
Display then User can configure
SNMPV2C and SNMPV3.
For configuration refer to section
“SNMP”, page 46.
7.4.10.4 Modbus
• Modbus
Modbus RTU configuration can
be done from T2S ETH web
page when logged in as expert
login.T2S ETH when used as a
standalone communication card it
only supports Modbus RTU. When
T2S ETH is connected to Catena
Display then User can configure
Modbus TCP.
For configuration refer to section
“Modbus Testing”, page 90.

CE+T Power T2S-ETH Specifications

General

Brand	CE+T Power
Model	T2S-ETH
Category	Industrial Equipment
Language	English