ChamSys QuickQ - 15 Open Sound Control (OSC)

Chapter 15. Open Sound Control (OSC)
Software version 6.0 onwards for QuickQ consoles supports Open Sound Control (OSC) from
3rd party control systems over a network such as the Touch OSC application for iOS/Android
devices.
Enable Open Sound Control in the Network Settings Window on the console, QuickQ is hard
coded to TX on port 9000 and RX on port 8000. Port number is fixed and cannot be changed.
Supported Open Sound Control commands are:
Table 1. Supported OSC Commands
Command Arguments OSC Action
/pb/<playback>
float between 0.0 and 1.0 or int between 0
and 100
Set playback fader
level
/pb/<playback>/go
(optional) non-zero value Go on playback
/pb/<playback>/flash
0 sets to 0%
non-zero sets to 100%
Set playback level to
100%
/pb/<playback>/pause
(optional) non-zero value Pause playback
/pb/<playback>/releas
e
(optional) non-zero value Release playback
/pb/<playback>/<cue>
(optional) non-zero value Jump to cue
/10scene/<item>/<zone
>
/10scene/<item>
(optional) one of following
no arguments - activate button
0- release button
1- activate button
Control 10Scene
buttons
/feedback/off
None Turns feedback off
/feedback/pb
/feedback/exec
/feedback/pb+exec
None Turns feedback on
and transmits state of
playbacks and
executes

Open Sound Control must be enabled in Settings › Network › Protocols for
these commands to work.
2021-03-12
QuickQ v6
57