Chapter 16. Ethernet Remote Control
QuickQ consoles feature a simple remote control protocol allowing them to be controlled
from 3rd party control systems over a network.
When Ethernet Remote Control is switched on in the Network Settings Window the console
will listen for UDP messages on port 6553. The port number is fixed and cannot be changed.
The Ethernet Remote Control messages do not require any heading.
Each command is an ASCII string with a number followed by a letter.
The supported commands are:
• A Activate Playback
• R Release Playback
• T Activate Playback at 100%
• U Release Playback 0%
• 'G' Go on Playback
• 'S' Stop (go back) on Playback
• 'L' Set Level of playback
• X Toggle 10Scene button (<zone>,<button ID>,<state>)
A number is prefixed before the command to denote the item that the command will control.
For example sending 10A will activate Playback 10, while sending 2X will toggle the second
button of the 10Scene panel.
Ethernet Remote Control must be enabled in Settings › Network › Protocols
for these commands to work.
58
QuickQ v6
2021-03-12
To Next Page
Loading...
Need help?
General
